The component ESP32 MODULE contains the ESP32 microchip which will be programmed. The component has two placeholders that are used for the ESP32-WROOM-32 or ESP32-WROVER.
You could only use one ESP32 module at one time. It's not possible to place both modules on the same time on the EBB board.
You find examples for each component in the component pages.
Activating the component¶
Active all four switches of SW210.
Using the component¶
It's necessary that all switches of SW210 are on and the switch at component POWER SUPPLY is on. This is necessary in order to establish the communication between the onboard USB programmer (component USB PROGRAMMING) and the esp32 module.
Examples of each component can be found on the component pages.
|Module||Datasheet from Expressif Systems|